How to Smoke Flake Tobacco - part II

"This article is provided by McClelland Tobacco Company

Five Steps to Success
1. Put in the palm of one hand the amount of tobacco that it is believed will fill the bowl. Then pinch at the slices or rub them between the palms until the tobacco separates to the degree preferred, keeping the texture even, avoiding clumps. The denser the tobacco is left, the slower it will burn. (This becomes especially valuable on windy days outdoors.)
2. Gently but firmly and evenly work the tobacco into the bowl of the pipe until it is filled slightly over the top and feels firm but still springy under enough finger pressure to flatten the surface of the tobacco even with the top of the pipe. (we assume the pipe is clean at the outset, free of obstruction to a good draft, well rested).
3. Now, while drawing through the stem, light the pipe evenly across the entire surface of the tobacco. After a few puffs to develop an ash, and while continuing to draw, tamp the tobacco down evenly all around the bowl with a tamper. The goal is to have the tobacco packed so that it will burn as evenly and firmly as a good cigar.
4. Relight the pipe after tamping to get the entire surface of the tobacco burning again. Even burning is very important. Otherwise, hot spots may develop.
5. With only occasional tamping as the tobacco burns down, since it tends to expand and loosen as it burns, the pipe should now smoke evenly to the bottom. The aim is to maintain a firm, even draft throughout the smoke. The process is not difficult to master and with practice will soon be effortless.
... (to be continued)"

下个商品 How to Smoke Flake Tobacco - part III